3D Spiderman Vinyl Wall Decal

Description

How about the great web-slinger himself crawling through your wall?

Made from non-toxic PVC vinyl.

Easy to apply & remove without damage to your wall (Please note vinyl wall decals can be applied and removed if needed, but not re-applied again after that. They are not designed to be removed & then re-used somewhere else.

Product size is approximately 600mm High x 900mm Long

Item will be shipped in a cardboard tube with end caps to protect your investment.

How to apply

Please follow these instructions to ensure your decal is applied correctly

Step 1: Get Yourself Ready

Pick your spot and check dimensions. Wall decals will stick well to smooth, indoor surfaces.

Recommended Surfaces:

• Smooth walls
• Painted Gib
• Glass
• Smooth metal
• Inside walls only

 Not Recommended Surfaces:

• Freshly painted walls – If the walls are freshly painted allow 14-30 days for the paint to dry and cure.
• Textured walls
• Unpainted gib walls
• Brick or concrete block walls
• Porous, textured walls
• Outside walls

Step 2: Prepare the Decal

Unroll the decal onto the floor, or a table – relax. If you had been rolled up into a tube for a while you would need to relax for a bit too. Lay out the decal for a couple of hours (sometimes a day), perhaps with something on it, until it stays completely flat with no curling.

Step 3: Prepare the Wall

Decals love clean walls – just like you love clean clothes.

If necessary clean the wall with a warm damp cloth and let it dry completely. (Do not use soap or cleaning agents)

Thoroughly clean walls of any dust whey a dry towel and cloth

Step 4: Get Help

Phone a friend or grab the closest person.

If you are putting up a large decal you may find yourself with not enough hands and control and will find that decal sticking to itself or parts of the wall you don’t want it too. Bad words will likely come out of your mouth at that point.

Step 5: Let’s Get It On

With the assistance from that friend you called - begin at the top of the decal and carefully and evenly peel it from its backing about a third of the way.

Place one corner in position and slowly smooth it along making sure it is level (or as level as you want it).

Slowly work your way down smoothing the decal into place with your hand, and peeling the backing off as you go in sections.

Use a flexible card (like a credit card for example) to smooth out any bubble working from the middle to the outside.

To give you an idea of how to do it check out this video
(note - your decal may vary slightly depending on shape and cutout and the sticker may peel from the front rather than the back, but the video will give you a general idea).